If I have a microphone hooked up to either channel in my duo, it sends only a left or right signal into live. Where can I make that a "stereo" left/right signal? IN live or IN the duo? It happens with both 3-Pin XLR and the 1/4"
Thanks for helping me out.
Duo into Live Mono/Stereo Issues
Hi,
In Live 2, the BusView contains an output and input section. In the input section you can set the input gain for every mono channel AND an 'link' button for every stereo channel pair.
If this 'link' button is on you can adjust the gain for both mono channels AND this stereo channel appears as a stereo in track's input routing.
If this 'link' button is off you can adjust different gain for each mono channels and both channels appear as seperate mono channels in track's input routing.
So you should switch 'link' off and select the with the microphone connected mono channel.
regards,
Alex
In Live 2, the BusView contains an output and input section. In the input section you can set the input gain for every mono channel AND an 'link' button for every stereo channel pair.
If this 'link' button is on you can adjust the gain for both mono channels AND this stereo channel appears as a stereo in track's input routing.
If this 'link' button is off you can adjust different gain for each mono channels and both channels appear as seperate mono channels in track's input routing.
So you should switch 'link' off and select the with the microphone connected mono channel.
regards,
Alex