How to avoid crackles and audio drop-outs
- Liveバージョン: 8 - 9
- オペレーティングシステム: ALL
An audio buffer size setting set too low or on a wrong size might be responsible for crackles and drop outs.
To change the Audio Buffer Size go to Preferences → Audio.
Please always use a value expressed in powers of two: 32, 64, 128, 256, 512, 1024.
Note that a larger buffer size will improve your system performance, but at the same time it will also increase the audio latency.
If the buffer size cannot be changed, please see if the following articles help:
Hard Disk Performance
If the hard disk cannot read or write audio quickly enough, this condition causes a gap in the recorded sample; when playing back, you will hear dropouts.
In this case you will be able to observe the Disk Overload indicator turn orange.
To avoid disk overload do the following:
- Use RAM mode for selected clips, by clicking twice on an audio Clip and activating the "RAM" button in the Sample box.
While doing this, make sure to monitor your RAM usage to avoid an Out of Memory error.
- Consider using lower sample rates (recommended: 44100 Hz) .
- Consider recording audio with a 24-bit resolution instead than 32-bit.
This setting can be found under Preferences → Record/Warp/Launch
- Consider bouncing some tracks together in order to save further HD resources. From the "Export Audio" dialog, you can also render a specific track to Mono. This will also reduce the workload of your Hard Disk.
Please refer to Live's manual, Chapter 32.2 for more tips on how to manage Disk Load.
Observe Live's CPU meter: if the value indicated there gets close to 100 percent, the processing is being maxed out and it’s likely that you will hear gaps, clicks or other audio problems. Note that the CPU meter takes into account only the load from processing audio, not other tasks the computer performs.
Please read this article for tips on optimizing your CPU usage.
Refer to Live manual, Chapter 32, for more insights on how to optimize your system resources.
Need more help?
Should issues persist, please make sure that your audio drivers and your OS are up to date.
It is always recommended to use the audio drivers that come with your audio interface, but if you are using a generic audio card on PC and you have problems finding an ASIO driver for that device, please try using Asio4All, which is a freeware universal ASIO driver.
If your audio card is connected via USB, please make sure to plug it directly to your Computer USB port and avoid using a USB hub.
Finally, on some new Macs and PCs USB 3.0 ports are installed. Please make sure that your audio interface is compatible with this protocol.